Report: Relay Take Off Ballots

Works out how many relay take-off ballot slips each relay judge needs for each relay event. First set up the relay events and judges on the Assignments tab, then enter the number of heats when you run the report.

Note: Meet Planner must be turned on for the meet.

Before you start: you're the meet's referee, an LSC administrator, or a planner for the meet.

Steps

  1. On the Home page, find the meet under My Meets and click Manage.
  2. Click the Assignments tab and choose the session.
  3. Below the pool, turn on This session has relay events.
  4. Choose the Number of Relay Events and each Relay Type.

    Relay eventsClick to see a larger version
  5. Choose a relay take-off judge for each position.

    Relay judgesClick to see a larger version
  6. Click Save positions.

  7. Click the Reports tab.
  8. On Relay Take Off Ballot Distribution, click Open.
  9. Enter the number of heats for each relay event, then click Generate Report.

    Number of heatsClick to see a larger version
  10. Each judge's lanes and the number of ballot slips they need are listed.

    Relay Take Off Ballot DistributionClick to see a larger version

Tips & troubleshooting

  • The number of heats matters - each judge needs one ballot per heat, so enter the real number of heats from the heat sheet. It isn't saved; enter it each time you run the report.
  • For long course meets, set Pool course on the Overview tab so start and turn side judges are both listed.
  • "This meet has no relay events configured" means step 3 hasn't been done for any session.
  • Download the report as PDF, XLSX, or DOCX to print it.

Related: Build deck assignments ยท Report: Radio Assignments

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.